Technical Information
Note:
When re-installing the cord in the cord reel, ensure that its end is firmly
pressed down into the strain relief and held securely.
5.18
Motor Assembly
5.18.1
S 25x
1. Remove the cap assembly (Section 5.6).
2. Take out the motor and disconnect its electrical connection.
3. The location of individual motor components is shown in Figure 5-33.
Important:
When re-installing the motor, care must be taken to ensure that the rubber
cushion (Figure 5-33, Item 3) and the motor seal (Figure 5-33, Item 13) are
correctly located.
Figure 5-33: S 25x Motor Assembly
1 Retaining screw
2 Holder
3 Rubber cushion
4 NTC resistor
5 Retaining screw
6 Thermostat
7 Speed control electronic
8 Retaining screw
9 Retaining screw
10 Interference suppression capacitor
S 2xx, S 3xx & S 4xx Canister Vacuums
11 Retaining screw
12 Bracket
13 Motor seal
14 Motor
15 Plug
16 Plug housing
17 Retaining screw
18 Motor brush
19 Clamping bracket
20 Retaining screw
48